Use and Care Manual

22
1
2
1
2
ASSEMBLY INSTRUCTIONS
2. Pull the plug for pump out from the opening molded in
the water tray. Push back rubber boot on the electrical
cord and plug water pump into receptacle. Pull boot
cover cord connections to help keep water off plug. Any
excess cord can be wrapped on the two hooks.
Note: The receptacle is only connected with the water
pump.
Note: The pump could also be used on a separate
bucket.
Installing the miter guide
The miter guide can be used from both the left and right
side of the cutting wheel.
1. Place slot on underside of the miter guide (O) on sliding
table fence. Lock the miter guide (O) securely to table
by turning lock knob clockwise.
O
1
2