Manualshelf

Use and Care Manual

ManualsBrandsVEVOR ManualsFlooringWet Tile Saw, 15-Amps 10 in. 65Mn Corded Wet Tile Saw, 4500 RPM, Tile Cutter Wet Saw with Water Reservoir and Casters
11121314151617181920
12
Installing Stand Assembly to Frame and Sliding Table
Assembly
1. Turn the sliding table lock knob (K) counter-clockwise
to horizontal position to lock the sliding table (I). Place
the frame and sliding table assembly (J) upside down
on the protective material.
Note: Place cardboard or an old blanket as protective
material on floor in order to protect the surface of the
sliding table.
2. Align the four stand holes with four frame holes, insert
hex bolt (CC) into one stand hole through two spacers
(EE), and frame hole, slightly tighten with hex nut (DD).
Repeat other three stand and frame holes. Tighten all
the hex nuts.
Note: The axles on stand are located on the opposite
side with the sliding table locking knob.
Note: Two spacers are opposite.
Hardware Used
ASSEMBLY INSTRUCTIONS
I
K
1
EE
CC
EE
DD
J
2
1
2
1
Spacer
Hex Nut
x 8
M8 x 85 Hex Bolt x 4
DD
FF
x 4
FF