Instructions / Assembly

90° Bends for 3/8"& 1/2" Tubing
Place mark."L"on the tube in the same manner as required for the 1/4”size.
For a bend to the left of the tube-clamping hook refer to Table 1.
Subtract from the original mark "L" the appropriate length, and place a
second mark "B"on the tube.This second mark "B" should be placed on
the right edge of the tube-clamping hook as shown in Fig.7.
For bends to the right of the tube clamping hook, place mark “R” on the
tube in the same manner as required for the 1/4^ size. Add to your mark
the distance shown in Table 2, placing a second mark *B"on the tube.This
second mark"B"should be placed on the right edge of the tube- clamping
hook as shown in Fig.7
7
.