Instructions / Assembly

Making Accurate 90° Center line Bends
90°BENDS FOR 1/4" TUBING
Determine the desired
Center line dimension
(Dimension “L” in Fig.4).
Measure from end of the
tube at “L” distance and
place a mark on the tube
(Mark “L”).
Position tube in bender as shown in Fig.5. If the end measured is left of
the tube-clamping hook the measured mark “L” should be directly under
the “L” graduation on the form lever face plate as shown in Fig.5. With a
steady motion, pull form lever handle around until the “O” mark on the
form lever is directly opposite the 90° graduation on the form wheel
(Fig. 5A). If the end that is to be measured is to the right of the tube
clamping hook, mark the tube at "R"distance and position directly below
the graduation “R” located on the form lever as shown in Fig.6, then
proceed with bend in the same manner as above
6
.