Instructions / Assembly

Making bends right of tube clamp hook
Table 2.This is for "R" Dimension and must be added to the center line
requirement
9
.
Tube
Diameter
Mark“B”
Fractions(Decimal)
3/8" 2-1/16"(2.062")
1/2" 2-17/64"(2.265")
Length Correction Factor for 90° Bends
To arrive at the exact tube length to fabricate a circuit, the following
method may be used.
Add all center-to-center dimensions of tube circuit . For each 90° bend,
subtract the amount shown in chart “A”. Circuits are dimensions to
square corners. Therefore the tube is always less.
Chart A
Maintenance / Service
Tube
Size
Bend
Radiu
Warranty
Your VEVOR 180° TUBE BENDER is warranted against defects in
materials and workmanship for a 12 month period from the date of
purchase. Faulty goods will be repaired or replaced at Vevor’s discretion
Have your tool serviced by a qualified repair person using only identical
replacement parts.This will ensure that the safety of the tool is maintained.
Disposal
This products should be disposed of in accordance with local regulations.
If you are unsure how to proceed, contact your local authority.
.
s
Correction
Factor
1/4" 11/16" .295
3/8" 1-1/8" .480
1/2" 1-1/2" .643