Use and Care Manual

- 5 -
2. Attach the front casters (J) by inserting
the stem of each caster through the end
of each leg and securing it with a flange
nut (U). Install the rear locking casters (K)
to the base frame in the same manner.
Lock the rear wheels in place for the
remainder of the installation.
3. Install the ladder assembly (B) by
inserting a frame bolt (N) through each
side of the base of a lock nut1 (V). Swing
the ladder's angle support (Fig.3 3-1) into the
height adjustment notches (3-2). Make sure
the crossbar is firmly in place.
4. Place the leg cross support (G) on both
legs (E&F), aligning the bolt holes. Insert a
cross support bolt (O) through each end of
the leg cross support and leg. Slide a washer
(T)over one bolt and secure with a lock nut
2(W). Repeat with the other cross support
bolt.
5. Attach the height adjustment plate (Q).
Match the angled opening with the