Technical Support and E-Warranty Certificate www.vevor.com/support FOLDABLE STEP STOOL MODEL: SQZDDGD004 We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
FOLDABLE STEP STOOL MODEL:SQZDDGD004 NEED HELP? CONTACT US! Have product questions? Need technical support? Please feel free to contact us: Technical Support and E-Warranty Certificate www.vevor.com/support This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received.
Thank you very much for choosing this foldable Step Stool . Please read all of the instructions before using it.The information will help you achieve the best possible results. SAFE WORKING PRACTICE 1. Smooth edges and corners to prevent scratching baby's skin. 2. Low center of gravity, large contact area with the ground, effectively preventing rollover. 3. The armrest stool is made of PE material, which is non-toxic, odorless, and odorless; Has high heat resistance. 4.
Left outer side panel Backboard 3nd pedal Right outer side panel Left inner side panel No.1 movable pedal Six point nut Right inner side panel 2nd pedal Screw Nut Installation steps Install the inner side panel (left) into the groove of the outer side panel (left) and tighten with screws and six point nuts.
Install the back panel into the inner side panel (left) as shown in the figure and tighten it with nuts (note that the letters on one side of the back panel must match the letters on the other side of the side panel). Install the No. 2 pedal into the outer side panel (left) and tighten with the nut. Install the No.1 movable pedal into the inner side panel (left).
Install the No. 3 pedal into the outer side panel (left) and tighten with the nut. Install the inner side panel (right) and tighten with nuts. Install the outer side panel (right) and connect it to the pedal with nuts, and connect it to the inner side panel (right) with screws and six point nuts. After installation, check if all nuts are tightened.
FOLDING STEPS 1. Rotate and move down the No.1 movable pedal. 2. Pull the side of the 2nd pedal that is not fixed upwards. 3. Move the outer side panel towards the inner side panel 4. Complete folding. INSTRUCTIONS FOR USE 1. Please place it on a flat and spacious ground for use, do not place it on water or permeable surfaces, uneven or rough surfaces, slopes, etc. 2. Before use, please check whether all components are secure, whether the product is shaking, and make adjustments. 3.
FAULT ANALYSIS AND TROUBLESHOOTING Fault Cause analysis phenomenon Exclusion method 1. Tighten the nuts and 1. The nuts were not tightened Folding armchair shaking instability during installation, and the components did not fit properly. 2. The ground is uneven adjust the position of the components to ensure that they are securely installed. 2. Use in a flat indoor environment. Warning 1. Only adults are allowed to install and children are not allowed to approach. 2.
Address：Baoshanqu Shuangchenglu 803long 11hao 1602A-1609shi Shanghai Imported to AUS: SIHAO PTY LTD, 1 ROKEVA STREETEASTWOOD NSW 2122 Australia Imported to USA: Sanven Technology Ltd.
Technical Support and E-Warranty Certificate www.vevor.
