Instructions / Assembly
TROUBLE SHOOTING
06
When the batte power is low, it needs charging, and the method is as below:
1. Take out the batte and charger from the box.
2. Connect the charger to the batte.
3. Connect the charger to the alternating current of 100-240V. The red indicator means charging.
4. The green indicator means nishing charging.
Notes: To make sure the batte using age longer, please recharge it timely; otherwise, it will make it
can not be recharged.
Charging
Problem
Show blue screen
Problems with
LED lights
1. Read the manual and check the correct way to turn on the light.
2. Check whether there is water in the front of the camera, which causes the
LED to not light up.
Not running
1. Check whether the batte power is sucient.
2. Check whether the display screen is damaged.
3. Check that the display screen is connected to the power supply normally.
Photo/video
cannot be saved
1. Check whether the memo card is damaged and need to be replaced.
2. Check if there is any foreign matter or deformation in the memo card slot.
Cannot format Memo card is damaged. Replace the memo card
Unable to charge
1. Check the charging po for foreign matters or deformation.
2. Check whether the charger is damaged.
3. When the batte is too low, it should be charged in time to prevent the
batte from being unable to charge due to loss.
Solution
1. Check whether the camera inteace is loose, and the camera is loose,
causing poor contact.
2. Check whether the connection of cable and power supply is normal or loose.
3. Check whether the monitor is connected to the power supply normally.
4. Check whether the cable is broken.
5. Check whether there is water in the front of the camera or if camera is
damaged.
6. When using the camera, please put on the protective cover rst, so as not
to cause the camera to collide with hard objects and damage, causing fail
to display images.