Instructions / Assembly

record the stock diameter at this point

of the link. Then measure stock

diameter in the same area on a link

that does not pass over the lift wheel

(use the link adjacent to the loose end

link for this purpose). Compare these

two measurements. If the stock diameter

of the worn link is 0.254 mm(or more).

Less than the stock diameter of the

unworn link, the chain must be replaced.

The chain length is 3 meter and it has

250 Knots.FIG 2.2 is specific dimensions

of the chain.

Lubrication

The gears are packed at assembly with grease and should not need to be

renewed unless the gears have been removed from the housing and degreased.

Bearing.

Rotor bearing are pre-lubricated and require no lubrication. Needle bearings are

packed at assembly with grease and should not to be relubricated. However, if the

housings, lift-wheel or sheave wheel have been degreased, these bearing should

be greased using lithium grease.

Load Chain Removal/Installation(FIG3& FIG4 &FIG5).

1. Remove the chain bag(FIG 3)

2. Remove the hook lock(FIG 4). Depress “up” button and run chain out of the

hoist.