Use and Care Manual

examine the interlink area for the point

of maximum wear. Measure and

record the stock diameter at this point

of the link. Then measure stock

diameter in the same area on a link

that does not pass over the lift wheel

(use the link adjacent to the loose end

link for this purpose). Compare these two

measurements. If the stock diameter of

the worn link is 0.254 mm(or more).

Less than the stock diameter of the unworn link, the chain must be replaced.

The chain length is 3 meters and it has 143 Knots.FIG 2.2 is specific dimensions of

the chain

Lubrication

The gears are packed at assembly with grease and should not need to be

renewed unless the gears have been removed from the housing and the grease is

removed.

Bearing.

Rotor bearings are lubricated and require no lubrication. Needle bearings are

packed at assembly with grease and should not to be re-lubricated. However, if the

housings, lift-wheel or sheave wheel have been decreased, these bearing should

be greased using lithium grease.

Load Chain Removal/Installation(FIG3& FIG4 &FIG5).

1. Remove the chain bag(FIG 3)

FIG 2.2

FIG 3