Instructions / Assembly

check below points:
①、
If the springs on the press wheels are too
tight,loose them.
②、
There are too much oil on the cables/wires,please
wipe it.
5.If see the blades tilted :
①
Check whether the center adjuster was loosed.
②
centering adjustment and adjust the screws of two
sides of it.
Make sure the cables/wires’ diameter are similar with the
feeding holes, large cables/wires in large feeding holes,small
cables/wires in small feeding holes, flat cables/wires in flat
feeding holes.
A：Flat cables/wires feeding hole