Instructions / Assembly

blades.
2.On the output side,if the cuts on the cables/wires are
too deep,please check below points:
①、
Please adjust the handles on the input side, screw
down or loose them. (M12 handles)
②、
Check whether the cables/wires on the right
position as you feeding them.
③、
Make sure the blades are sharp,if not,polish them
with the oil stone
3.On the output side, if you find the plastic(PVC)has
been stripped,but the copper wires can not been
disgorged,please check below 4 points:
①
polish The axis of the upside with the oil stone
②Check whether the springs are loose, if yes, screw
down to make them tighten
③
The diameter of the cables/wires are too small, please
adjust the space between the two axises to
0.3-0.6mm.
④
If the cables/wires you want to strip are hot,also can
not get the copper wires stripped out.
4.If the cables/wires were blocked in the axises,please