Instructions / Assembly

ManualsBrandsVEVOR ManualsHand ToolsElectric Cable Stripping Machine 370-Watt 0.06 in. to 0.15 in. Automatic Wire Stripper with 11 Channels 10 Blades

Table Of Contents

②Check whether the springs are loos

Wire Stripper Manual

Wire Stripping range: Φ1.5mm~ 38mm

This machine is easy to operate and convenient to carry, can

process single core copper wire, twin cores copper wire.

Measurement: L44cm × W30.5cm × H36cm

Weight

：

25.5kg

1.Comparing the cables/wires’ diameters with the

feeding holes on the machine, feeding the cables/wires one off

the head of the cables/wires, to avoid gaps caused to the

Summary of content (4 pages)

PAGE 1
Wire Stripper Manual Wire Stripping range: Φ1.5mm~ 38mm This machine is easy to operate and convenient to carry, can process single core copper wire, twin cores copper wire. Measurement: L44cm × W30.5cm × H36cm Weight：25.5kg 1.
PAGE 2
blades. 2.On the output side,if the cuts on the cables/wires are too deep,please check below points: ①、 Please adjust the handles on the input side, screw down or loose them. (M12 handles) ②、 Check whether the cables/wires on the right position as you feeding them. ③、 Make sure the blades are sharp,if not,polish them with the oil stone 3.
PAGE 3
check below points: ①、 If the springs on the press wheels are too tight,loose them. ②、 There are too much oil on the cables/wires,please wipe it. 5.If see the blades tilted : ①Check whether the center adjuster was loosed. ②centering adjustment and adjust the screws of two sides of it. Make sure the cables/wires’ diameter are similar with the feeding holes, large cables/wires in large feeding holes,small cables/wires in small feeding holes, flat cables/wires in flat feeding holes.
PAGE 4
B：Cables/Wires’ Feeding Hole Diameter: 1.5-6.0mm C：Cables/Wires’ Feeding Hole Diameter: 6.0-9.0mm D：Cables/Wires’ Feeding Hole Diameter: 9.0-13.0mm E：Cables/Wires’ Feeding Hole Diameter: 13.0-16.0mm F：Cables/Wires’ Feeding Hole Diameter: 16.0-19.0mm G：Cables/Wires’ Feeding Hole Diameter: 19.0-24.0mm H：Cables/Wires’ Feeding Hole Diameter: 24.0-28.0mm I：Cables/Wires’ Feeding Hole Diameter: 28.0-38.