Use and Care Manual

- 7 -
6. Finally connect the lines correctly, (Refer to WIRING DIAGRAM)
Note: Make sure the product is firm and the wiring is right before power
on
WIRING DIAGRAM
POWERING AND SETUP
Step 1:
Plug the fan’s 3-pin connector into the universal controller’s out 1 or out 2
port signified by the fan/power symbol.Plug the sensor’s 4-pin connector
into the controller’s sensor signified by the controller symbol.See
the(Fig.3.)
Fig.3.
Step 2:
Lastly, to power both the fan and controller, plug the fans power cord into