Use and Care Manual

- 14 -
TRIGGER MODE: LOW HUMIDITY
In this mode, pressing the up or down button sets the low humidity trigger.
The fan will activate if the probe’s reading meets or falls below the trigger.
It will gradually ramp up until it reaches the ON Mode’s setting. If the
probe’s reading rises above your trigger, the fan will turn off. We
recommend turning this trigger OFF when not in use during set up by
holding the up and down buttons together.
You may set this trigger above the high humidity trigger to create a range
where the fan is active.
Note that this trigger can activate as long as you are in AUTO Mode,
even if you are viewing a different trigger within AUTO Mode.
ALARM SETTING: HIGH TEMPERATURE
In this mode, pressing the up and down button sets a high temperature
alarm. The alarm will sound and its icon will flash if the probe’s reading
exceeds the set temperature.
To activate the alarm, leave the alarm mode. The alarm will turn
OFF if the probe’s reading falls below the trigger or if any button is
pressed. You can also set the alarm OFF by holding the up and down
buttons together.
You may set this alarm below the low temperature trigger to create an
operating range.