Use and Care Manual

- 11 -
to 1 if the device is left unattended for 30 seconds. Holding the up or down
button will change the display’s units to F or C, respectively.
TIMER MODE
In this mode, pressing the up or down button will set the timer. The fan will
ramp up to ON Mode’s setting until the timer’s clock runs out. It will begin
spinning 5 seconds after the timer is set.
Leaving the timer mode while it’s running will pause it until you return to
this mode.
TRIGGER MODE: HIGH TEMPERATURE
In this mode, pressing the up or down button sets the high temperature
trigger. The fan will activate if the probe’s reading meets or exceeds this
trigger.
It will gradually ramp up until it reaches the ON Mode’s setting. If the
probe’s reading falls below your trigger, the fan will turn off. We
recommend turning this trigger OFF when not in use during set up by
holding the up and down buttons together.