Use and Care Manual

- 15 -
need a spray bottle, brush or rag to apply the solution to the fittings.
TO TEST
1.Turn the burner valve OFF.
2.Turn the liquid propane cylinder valve on counterclockwise to open the
valve.
3.Apply the soap solution to all gas fittings. Soap bubbles would appear
where a leak is present.
4.If a leak is present, immediately turn the gas supply OFF and tighten
leaky fittings.
5.Turn the gas back ON and recheck.
6.Should the gas continue to leak from any of the fittings, turn the gas
supply OFF and contact customer service.
OPERATING INSTRUCTIONS
USING THE OVEN
Each burner is rated at 13600 BTU/Hr.
To begin:
1.Make sure the oven has been leak tested and properly placed.
2.Remove any remaining packing material.
3.Light the burner using the LIGHTING INSTRUCTIONS below
LIGHTING INSTRUCTION
TO LIGHT THE BURNER
1.Make sure the control knob is in OFF position, and then turn the liquid
propane cylinder valve ON by slowly turning counterclockwise.
2.Push in and slowly turn the control knob anticlockwise until you hear a
click and the burner ignites.
3.If burner doesn't light, turn the knob OFF, wait 5 minutes and repeat the
lighting.