Use and Care Manual

- 14 -
GAS REGULATOR
This gas fitting is clockwise. Make sure that the tank is completely
switched off and screw the regulator as far as possible into the gas tank
valve.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1.To connect the liquid propane gas cylinder:
2.The cylinder valve should be in OFF position.
3.Make sure the burner valve is in OFF position.
4.Inspect the valve connections, port and regulator assembly. Remove
debris and inspect the hose for damage.
5.When connecting the regulator assembly to the valve, tighten the nut
clockwise by hand until it stops.Use of a wrench could damage the quick
coupling nut and result in a hazardous situation.
6.Open the cylinder valve fully by turning the valve counterclockwise.
7.Before lighting the oven, use a soap and water solution to check all
connections for leaks.
8.If a leak is found, turn the cylinder valve OFF, and do not use the oven
until local liquid propane dealer can make repairs.
CONNECTING THE LIQUID PROPANE GAS CYLINDER
1.Turn the oven burner valve OFF and make sure the oven is cool.
2.Turn the liquid propane cylinder valve OFF by turning clockwise until it
stops.
3.Detach the regulator assembly from the cylinder valve by turning the
quick coupling nut counterclockwise.
4.Place dust cap for cylinder valve outlet whenever the cylinder is not in
use.
LEAK TESTING
GENERAL
Although the gas connections of the appliance are leak tested prior to
packing and shipment, a complete test must be performed at the
installation site.
Before each use, check all the gas connections for leak testing using the
procedure listed below. If the smell of gas is detected at any time, you
should immediately stop using and check the entire system for leaks.
BEFORE TESTING
Make sure all packing material has been removed from the appliance.
Make a solution of one part liquid detergent and one part water. You will