Instructions / Assembly

Wire stripper operating(instruction) manual
Wire Stripping range: Φ1.5mm~ 13mm
Measurement:L42cm×W34cm×H50cm
Weight
：
32.5kg
Please note that there will be a little bit errors in actual use
1.Push the Switch up to turn the Motor ON,Check whether the
machine work well.Make sure there are no people on the output side of the
machine.Comparing the cables/wires’diameters with the feeding holes on the
machine,feeding the cables/wires one piece at one time.Before feeding the
cables/wires,please cut off the head of the cables/wires,to avoid gaps caused
to the blades.
2.On the output side,if the cuts on the cables/wires are too deep,please
check below points:
1 、
Please adjust the handles on the input side, screw down or loose
them. (M12 handles)
2 、
Check whether the cables/wires on the right position as you
feeding them.
3 、
Make sure the blades are sharp,if not,polish them with the oil
stone
3.If the cables/wires were Blocked in the axises,please check below
points:
1 、
If the springs on the press wheels are too tight,loose them.
2 、
There are too much oil on the cables/wires,please wipe it(make
sure the machine is turned off when you wipe the axises)