Use and Care Manual

-”, and the machine will buzz and stop working at the same time.

2. The rotating speed of drive motor is too slow, the screen will show “NL”,

and the machine will buzz and stop working at the same time.

3.If the limit switch behind the dispenser door is connected to the power for

over 1 minute, the screen will show “Cb”, and the machine will buzz and stop

working at the same time.

4. If the mix in hopper is not low, the screen will show“QL”

B. Making Ice Cream

1. Rinsing before making the ice cream

1.1 Prepare 3 liters of solution using sanitizer in bucket of cold water, pour the

solution into the

hopper and clean all the surface parts of the hopper carefully.

1.2 Turn on the main power, press “WASH” button and let the machine run for 3

minutes.

1.3 Place a bucket beneath the dispenser door, pull down the handle to drain

out the solution.

1.4 When solution comes out, press “WASH” button to quit the washing mode.

1.5 Unscrew two bolts of dispenser door, take off the dispenser door assembly

and remove all

the part from it, put all the parts into the solution for cleaning, then

reassembly the

Parts and install the dispenser door assembly back to the machine.

1.6 Pour moderate amount of clean water into the hopper and drain the water

out, repeat the

above steps until the water becomes as clear as possible.

1.7 At last, dry off the dispenser door with a dry, clean, lint-free towel.