Use and Care Manual

P1 is not suggested to adjust.

.Instruction for functionⅡ

2.1 Wash

Press the “WASH” button to enter into the washing mode when the machine is

in standby, then the drive motor will turn on, press the “WASH” button again

to quit the washing mode.Press the “WASH” button for 10 seconds to enter

into the online speed measurement function and can measure the current no

load speed of the motor.

2.2 Keep Fresh

Press the “Keep Fresh”button to enter into the keep fresh mode,the

compressor is working to freeze the frozen cylinder until it is 70% frozen,the

solenoid valve of freezing is off and the solenoid valve of pre-cooling is on,

when the temperature of hopper reach the setting temperature(P0), the

solenoid valve of pre-cooling and compressor stop. The compressor will

continue to freeze the frozen cylinder when the P3 reaches.

2.3 Auto

Press the “Auto”button to enter into the auto mode,the compressor is working

to freeze the frozen cylinder until it is 100%

frozen.Then the compressor will continue to work to freeze the hopper until it

reach the setting temperature(P0).

Alert functionⅢ

1. If the RPM can not be detected by the limit switch, the screen will show “-

N Meaning Prom Scope of Default

1 Hopper pre-cooling temperature P0 1--19℃ 4℃

2 Frozen cylinder keep fresh P1 1--10℃ 4℃

3 Hopper pre-cooling temperature P2 1--10℃ 2℃

4 Compressor restart period setting P3 2-15min 15min

5 Compressor restart period setting P4 1--15min 5min

6 Beater motor shutdown delay P5 1-- 30secon