Use and Care Manual

7
6. Use the clean water to repeat the above steps 2-3 times.
> OPERATING INSTRUCTION<
A. Front Panel
. Instructions for settingⅠ
1.1 Cup counting checking and reset function: it will show the counting while
pressing the“UP”and“DOWN” buttons
together（Only when in auto mode, and only count when the micro-switch works），
it will return to the previous state if no operation for more than 5 seconds. And
the counting will be cleared away if pressing the “UP”and“DOWN”buttons
together for 5 Second.
1.2 Firmness setting: Under standby state, press“UP ”for 1 second, “HARD/SET”
window flashing, then
press“UP”or“DOWN”to adjust the firmness (from 1 to 10). The level value will
be saved and return to the standby state if no operation for more than 5 seconds.
1.3 Temperature checking function: Press“UP ”for 3 seconds, you can check the
temperature of hopper and cylinder.
1.4 System parameter setting: Press“SET ”for 3 seconds, and continue to press
“SET ”from P0 to P5, you can press “UP”or“DOWN” to adjust the parameter
when prompt change, the details are as follows:
1. The temperature of the solutions should be less than 60℃, or it
will damage the parts.
2. After the cleaning, please make sure no any water in the cylinder,
or the frozen ice will damage the auger when the machine is
freezing.