Use and Care Manual

14
>TROUBLE SHOOTING AND SOLUTION<
Some problems may happen to the machine, the corresponding solutions have been
listed on the following trouble shooting sheet for your reference, if the problem persists,
please don’t handle it by yourself and contact our professional technicians for help, in
order to avoid unnecessary loss.
PROBLEM PROBABLE CAUSES SOLUTIONS
Machine does
not run
Machine is not plugged in. Check it and plug it properly.
The general switch is not on.
Turn the general switch on.
The general switch is broken. Replace the general switch with new one.
Protective circuit works. Change the fuse.
The washing mode
does not work
The wiring for this function
is loose.
Check the wiring and make it connected.
The drive motor is not
working.
Repair the motor or replace it.
The AUTO mode or
does not work
The wiring for this
function is loose.
Check the wiring and make it
connected.
The control board is not
active
Replace the control board.
Compressor does
not work
The voltage is low. Try to get a high and stable voltage.
The relay is bad. Replace the control board.
There is something wrong
with control board.
Replace the control board.
The overload protection is
working.
Find the cause and restart.
The compressor is bad. Replace the compressor.
The capacitor for
compressor is not
Replace the capacitor.