Use and Care Manual

12
while assembling the piston, O-ring and gasket.
2. Cleaning of the exterior of machine
Keep the exterior of machine clean, use wet towel to clean it, and do not flush the machine
with water directly.
3. Cleaning of condenser
After be used over a period of time, the condenser maybe thick with dust, and this will
effect heat dissipation and cause bad refrigeration, so it needs periodic cleaning (every
half year).
Cleaning methods:
Step 1: Disconnected the main power switch.
Step 2: Remove the back panel and side panels.
Step 3: Clean dust with tools such as vacuum cleaner, high-pressure air and soft brush, be
careful while cleaning to avoid damaging the fins of the condenser.
B. Maintenance Tip
 Be sure to drain the product, and thoroughly clean and sanitize your unit daily. Proper
cleaning and preventative maintenance results in a creamier product consistency,
increases your unit reliability and efficiency, and prevents costly repairs from occurring
in the future.
 Do not run the machine while the machine is empty. This can severely damage the
1. B efore installing the piston, O-ring for piston, beater and gasket for
auger, you should lubricate Vaseline (lubricating Vaseline onto the
groove of the gasket, do not onto the auger’s end ), using the Vaseline