Technical data

Empty fuel filter
• Open the drain plug at the lower side of
the filter.
• Drain the water and close the drain
plug.
Empty water separator
Empty the separately installed water sepa-
rator/fuel filter:
• Open the drain plug at the lower side of
the filter.
• Drain the water and close the drain
plug.
Note : The water separator is not within
the scope of supply but installation is
required!
Bleeding
After the water separator/fuel filter has
been drained, the air has to be bled from
the fuel system
The fuel system is self-bleeding; but manu-
al bleeding the system is recommended.
Open the two bleeding nipples.
One (1) bleeding nipple is located at the
filter.
Maintenance
Draining of water from the water separator/fuel filter
Every 100 operating hours.
26
CT30119
VD01006 VD01007
13