Product Manual

Table of Contents Rev. 9/13/2019 LL-PMPS MANUAL
Table of Contents Copyright 2019 Vestil Manufacturing Corp. Page 12 of 22
LOADING INSTRUCTIONS
The capacity of this LL-PMPS-series lifter is 1,200 lb. Every unit is
labeled with this information (label 287 on p. 21). DO NOT attempt to lift
loads that exceed the 1,200 lb. (545.5kg) capacity! Personal injury or
permanent damage to the lifter might occur.
When applying a load to the forks, always follow these guidelines:
1. The load should firmly contact the heels of the forks
2. DO NOT apply a load to the tips of the forks
3. Center the load on the forks
4. Only transport loads in the lowered position
5. Apply the caster locks of both rear casters while loading,
unloading, and storing the lifter.
6. ONLY use the lifter on level, even ground.
ADJUSTING THE OUTRIGGERS
[NOTE: Always unload the lifter before
beginning the outrigger adjustment process.]
To adjust the outriggers:
1. Loosen the socket cap screws (13) in the
leg clamp brackets.
2. Slide the outriggers through the brackets
until the desired stance is achieved. The
outriggers should be an equal distance from
the center line. Maximum separation
(measured from inside-to-inside of
outriggers) must not be more than
50
1
/
2
inches.
3. Tighten the cap screws to 45ft∙lb with a
torque wrench.
MODULAR POWER UNIT LAYOUT: 115VAC
Socket cap
screws
Leg clamp bracket
Leg
Center line
Overhead view
Separation
between
outriggers
measured
from inside
to inside.
Leg
Outrigger
Caster lock: press
down to lock; lift
up to unlock)