Product Manual

LOW CEILING JIB CRANE IS SHIPPED IN 2 SECTIONS,

FRAME ASSEMBLY & PIVOT BRACKETS

1) Drill holes at desired height on a steel column using the

dimensions as shown. Make sure that the holes are centered

on the column.

2) Bolt the mounting brackets to the column with suitable

fasteners.

WALL JIB (FOR LOW CEILINGS)

Model JIB-LC-3-92, JIB-LC-6-92, JIB-LC-10-92 & JIB-LC-20-92

WARNING! This equipment

is not designed for and

should not be supporting or

transporting personnel.

LOW CEILING JIB CRANE IS SHIPPED IN 2 SECTIONS,

FRAME ASSEMBLY & PIVOT BRACKETS

1) After brackets are mounted, (28-126-012) place thrust

bearing (A) under bearing boss (B).

2) Align bearing boss (B) with the holes inside the mounting

bracket (C) on the column.

3) Place rod (D) through the holes of the mounting bracket

and the bearing boss (B).

4) Place 1-1/8 flat washers (E) on both ends of the rod (D).

5) Tighten both ends of the rod with 1-1/8" nuts (F), be sure

that there is even amount of threads on both ends of the rod

(D). Allow a 1/4" gap between.

6) Repeat steps 1-5 for the bottom assembly.

7) Shim between pivot bracket and mounting beam to level jib

boom.

1-11/16"

CENTER

50-1/4"

COLUMN

13/16" DRILL

THROUGH 1ST

FLANGE 12 PLACES

FRAME ASSEMBLY

PIVOT

BRACKETS