Product Manual

Rev. 0213 EPT, Manual.doc

Step 2: Remove the black plastic cover by lifting it as shown below; then remove battery wiring from the negative

post with 13mm wrench (negative terminal identified with a white arrow). There will be one large black wire, and

one smaller black wire. The smaller black wire connects to the battery charger.

Step 3

: Follow the wires that connect the charger to the batteries from the bottom of the charger (circled in the

photograph below) to the ends of each wire, which connect to the positive and negative battery terminals. Once you

understand how the wires get from the charger to the battery compartment, carefully pull the two battery charger wires

out of the battery compartment.

Step 4

: Disconnect the red cable from the positive terminal.