Product Manual

Rev. 0213 EPT, Manual.doc

Plug the charger’s AC cord into an 115VAC power source:

 EPT-30’s

: to access the cord, remove the top tray.

 EPT-45’s

: the AC cord is tucked inside the battery box on the right side (circled in the second photo

below)

Plug this end into a standard 115 volt outlet and charge batteries for at least 8 hours. The charger will not

overcharge the batteries, so leaving the unit plugged in overnight or over a weekend is ok. However, the charger

should only be used indoors! When the charge cycle completes, disconnect the AC cord from the outlet, and

reinstall the tray (EPT-30’s).

Storing the EPT

: Unload the lifter; then return it to the designated storage location.





AC charger

cord

A proper storage location is one where the unused lifter will not:

1. Interfere with or obstruct traffic or other operations;

2. Be exposed to corrosive chemicals or water, either as a consequence of weather or of worksite

conditions.