Product Manual B

Rev. 0213 EPT, Manual.doc

Step 5

: Four mounting studs project through the base of the charger to secure it in place. Remove the nuts with a

deep well 10mm socket, or small 10 mm wrench; then pull the charger off of the retaining bolts.

Step 6: Once the old battery charger is removed, the replacement charger can be installed. The new charger is

attached to a mounting bracket (blue in the photograph below) so that it can install onto the 4 mounting studs. Install

the new charger with the pigtail electrical cord facing downwards and the LED’s facing upwards.

Step 7

: Secure the new charger in position by winding the nuts back onto the mounting studs. Feed the wires labeled

“POS” and “NEG” into the battery compartment following the same path noted in Step 4

Mounting studs

& 10mm Nuts

The mounting studs may be damaged if the nuts are over-tightened. Stop tightening each nut

when you first begin to feel resistance.