Product Manual B

Rev. 0213 EPT, Manual.doc

Step 9: Install a new controller by reversing steps 1 through 8.

Step 6: After you have unfastened all 4 of the cable connections (first photograph below); then remove the three

8mm screws (1 screw in back and 2 in the front) holding the motor controller to the back plate with a Philips

screwdriver, and 8mm wrench.

Step 7: Remove the motor controller.

Step 8: Verify that each of the 4 spade terminal

connections on the forward / reverse motor

contactor is sound.