Product Manual B

Rev. 0213 EPT, Manual.doc

Step 3: Remove the two (1 front, 1 back) 14mm bolts that fasten the motor controller mounting plate (identified with a

yellow asterisk) to the frame.

Step 2

: If necessary, mark each of the cables with a unique identifier to make it easier to reconnect them to the new

motor controller. For instance, in the photograph below the red and green insulated ring terminals display a distinct

number of hash marks to indicate order of attachment from top to bottom. In newer EPT’s, a yellow tag marked with a

specific letter identifies each cable. The diagram below and to the right indicates where cables A through I attach to

the Motor Controller or the Forward/Reverse Contactor.

Step 4: Remove the Molex connector from

the motor controller.

Step 5: Disconnect the motor controller wiring with two

14mm wrenches.

Motor Controlle

Forward/Reverse Contacto