Product Manual B

Rev. 0213 EPT, Manual.doc

Step 8

: Install the bushings onto the throttle wheel shaft. Notice that the bushing must be installed as shown the drawing

to the right of Photo 16 below.

Step 9

: Install the throttle wheels, and secure them to the wheel shaft with Philips head screws.

Step 10

: To fasten the tiller assembly to the handle, first insert the assembly aligning tabs (circled in Photo 19; NOTE:

Tabs underneath the switch cover; Photo 19) into the slots in the handle tongue shown in photos 20 and 21 and identified

with arrows in the magnified view. An Exploded Parts Diagram appears on the next page.

This end onto

wheel shaft

17 18

Magnified view of Handle Tongue

(arrows point to aligning tab slots)

NOTE: In order

to show the

aligning tabs,

the switch

cover does not

appear in this

icture.