Product Manual B

Rev. 0213 EPT, Manual.doc

Step 2

: Carefully pull the (red) belly switch cover away from the handle while continuing to lift the base of the housing.

The housing should separate from the handle as shown in photo 4.

Step 3: Unplug the two connectors shown in photo 5. [NOTE: Wires may not attach to connectors. If this is the case,

record the wire combinations before you separate them!]

At this point, the entire assembly can be replaced with a new one by simply plugging the replacement

assembly into the two connectors. If the problem appears to be in the belly switch, continue to disassemble the

throttle. Remove the Philips screw located at the center of the throttle control wheel (photo 6).

Step 4: Note the orientation of the control wheel on the shaft (correct orientation shown in Photo 7); then slide the it off

of the shaft. Remove the remaining wheel from the other side; note the orientation of the two plastic bushings (identified

with arrows in photo 8). If the wheels stick or grind when rotated, contact Vestil to request replacement

bushings.

3 4

5 6

7 8

Do not drop the assembly once it is disconnected from the handle, because the wires might be

damaged or might rip out of the connectors