Product Manual

B
B
A
A
T
T
T
T
E
E
R
R
Y
Y
&
&
B
B
A
A
T
T
T
T
E
E
R
R
Y
Y
C
C
H
H
A
A
R
R
G
G
E
E
R
R
The batteries and battery charger are packed inside the battery pack. Follow the operating procedures to charge
battery:
5.1 Turn switch key CCW to turn off the power supply.
5.2 Disconnect the battery cable connector from compartment of the truck and then fully engaged it to the
compartment of the battery charger.
5.3 Before connecting the battery charger to the local power supply, check and insure that the voltage of both is
the same.
5.4 Connect the AC extension cord from the charger into the outlet of local power supply. This will automatically
turn the charger on, and it will run at a rate commensurate with the requirements of the batteries. The charger
will automatically control the charging procedure and when the batteries are fully charged, the charger will
only supply enough current to maintain batteries charge.
5.5 When the charging cycle is completed, disconnect the AC plug from the truck outlet and the power supply.
5.6 Remove the battery connector from charger and fully engaged it to the drive plug.
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
6.1 Only trained and authorized personnel should be permitted to maintain, repair, and inspect the unit.
6.2 Keep usage area cry, clean, and well ventilated.
6.3 To avoid fire hazards, have fire protection equipment present at all times during any maintenance or repair.
Do not use open pans or containers of flammable cleaning fluids.
6.4 Safety devices shall be inspected at regular intervals and maintained to a safe operating condition.
6.5 Electrical components shall be maintained and inspected for safe operation. Condition of electrical insulation
is very important.
6.6 Battery electrolyte level should be checked before charging the battery. The level should be maintained at
1/2 inch above the plates. If the level is low, and either approved local supplier or water at the end of charging.
Do not overfill. It is not necessary to charge the battery every day if there are more than 1/3 left, however the
battery should be charged at least once a week.
6.7 Disconnect batteries before working with the electrical system.
6.8 When checking the hydraulic fluid level, make certain that the unit is fully lowered and on a level floor.
Remove the filler cap and check the level of the fluid. Use a top quality hydraulic fluid. Do not use hydraulic
brake fluid.
6.9 Before leaving the unit, stop the unit, lower forks fully and turn off power and remove key.
6.10 Before working on the unit, lower forks fully, check that brake is working properly and turn off power and
restrain unit using chocks or other restraining devices.