INTRODUCTION Welcome to use our Floor crane. WCF series of floor crane is designed with fixed legs with adjustable length, WCE is designed with adjustable width straddle legs and WCR is designed with none leg with counter balance weight. It is developed for used in workshop, maintenance and logistic area. Working in workshop, you could use it to pick up and reposition of heave pieces of work, machine tools, chucks, steel bar/plate etc.
BEFORE OPERATION 2.1 Make sure that the battery cable connector is fully engaged into the battery compartment of the truck. 2.2 Check if there is full of battery supply. 2.3 Check if the truck is working properly. Give special attention to horn, speed controller and steering system. 2.4 Observe the condition of the truck for any other malfunction or defect. 2.5 Before leaving the unit, stop the unit and turn off power.
OPERATION 3.1 TO RAISE AND LOWER There are two buttons located on the right side of the handle. One is for raising the hook. The other one is for lowering the hook. Make sure that there is no one standing near the truck or the load when raising or lowering. 3.2 TO TRAVEL The butterfly switch controls the direction and speed of the lift truck. Rotate the butterfly controls located on the upper part of the handle.
TROUBLE SHOOTING If the truck fails any of these tests, do not operate this truck until the problem is resolved 4.1 Read and understand Operator’s Manual before using the truck. 4.2 Make sure that the battery cable connector is fully engaged into the battery compartment of the truck. 4.3 Make sure there has not any leakage of oil from previous use. 4.4 Turn the key switch on and check the battery meter to ensure if there is full of battery supply. 4.
- Emergency disconnect button depressed - Faulty SB connector - Loose battery connections - Blown control or power fuse (or unplugged) Faulty wiring from fuse to travel control switch Faulty travel control switch NO ELECTRICAL POWER Faulty wiring from travel control switch t direction contactor Faulty contactor Check traction motor
BATTERY & BATTERY CHARGER The batteries and battery charger are packed inside the battery pack. Follow the operating procedures to charge battery: 5.1 Turn switch key CCW to turn off the power supply. 5.2 Disconnect the battery cable connector from compartment of the truck and then fully engaged it to the compartment of the battery charger. 5.3 Before connecting the battery charger to the local power supply, check and insure that the voltage of both is the same. 5.
SPECIFICATION Model Capacity Lift Height Load Lift Speed Unload Load Lower speed Unload Load Travel speed Unload Drive Motor Lift Motor Battery Battery Charger Gradeability Overall size EPFC-25 2,500/1,300/600 lbs 45¼ - 130” 1/2”/s 0.70”/s ¾”/s ¼”/s 2.18m/h 2.8m/h 24V/700W DC24V/2.
EPFC-25 (Electric Powered Floor Crane) 94" (2388mm) 70" (1778mm) 13½"(342) 30"(760mm) 24"(610mm) 46 7/8 - 131" (1190-3328mm) 1300 lbs (590 kgs) Ø10x3.15"( 8¼"(210) 254×80) 7½" (190) 1.38" (35mm) 29¾" (755mm) L.H: 22" R.H:70" 50"(1270mm) 63"(1600mm) 2500 lbs (1133 kgs.) 3 - 8" (203.3mm) 600 lbs (272 kgs) L.H: 12½" R.H:90" 2 - Ø6X2"(Ø150X50) 7"(179mm) 35½"(900mm) 30"(760mm) 30"(760mm) 60.
