ALL-T-GPT Owner’s Manual Kill Bale Parking Brake Frame Engine Lift Carriage Throttle Forks Drive wheels Hydraulic Cylinder 5/23/2008 Major Components Vestil Manufacturing 1
WARNINGS & SAFETY INSTRUCTIONS Warning: Failure to follow all instructions and warnings may result in serious injury or death! Be aware of and comply with all Federal, State, Local, ANSI, OSHA and all other codes and regulations. Read owner's manual completely before operating unit! • Do not operate this truck unless you are trained and authorized. • Do not overload the truck. Check capacity plate for loading weight and lifting height. Do not handle unstable or loosely stacked loads.
RECEIVING INSTRUCTIONS Every unit is thoroughly tested and inspected prior to shipment. However, it is possible that the unit may incur damage during transit. If you see damage when unloading make a note of it on the SHIPPER RECEIVER. Remove all packing and strapping material, inspect for damage. IF DAMAGE IS EVIDENT, FILE A CLAIM WITH THE CARRIER IMMEDIATELY! Also, check the unit size, type of power unit, etc.
few minutes you should get the feel for shifting the transaxle. When moving heavy loads, it may be necessary to slow the unit down with the shift lever resulting is less power demand. Do not shift from forward to reverse rapidly! The change can cause the load to shift on the forks and may damage transaxle. Raising and lowering a load. Raising a load: Release the shift lever. Speed the engine up to mid speed and lift the valve lever gently with your hand. The load should start to rise.
this happens raise the load to reset the velocity fuse. Adjust the adjustment screw to decrease lowering speed. Raise Load Lever Lower Speed Adjustment Lower Load Parking Brake The ALL-T-GPT is equipped with a locking parking brake. This brake is not intended to be used as a dynamic brake for slowing while engine is engaged or for steep grades. To operate brake, simply pull the lever back until it locks. Push the lever forward to release.
Transaxle Release If the unit needs to be moved without the engine running, the transaxle must be disengaged. Push the transaxle release leave forward then down, to disengage the transaxle.
Lifting The unit can be lifted by using the two holes located in the carriage channels. Use proper clevises and chains (not supplied with unit). \ Maintenance The ALL-T-GPT should provide years of operation with little maintenance. Follow the engine manufacture’s recommendations on maintaining the engine.
oil change, check the drive chain tension and lubricate the drive chains with sticky spray grease. The chains should be slightly loose (not tight) but not loose enough to allow the chain to slap or jump. Inspect and lube the chains by removing the tube chain covers. Adjust the chains by loosing the lock nut and applying tension on the hex. Tube Chain Cover Hex Lock Nut There are set screws on the front and rear sprockets, the drive shaft coupling, motor pulley, and pump pulley.
Parking brake handle Cotter key Rod nut The belt tension is spring loaded and requires no adjustment. Check hydraulic oil level and refill as necessary. Use an ISO 32 general purpose hydraulic oil. Fill to 1” from top with cylinder in down position.
PRODUCT WARRANTY ONE YEAR LIMITED WARRANTY The manufacturer warrants for the original purchaser against defects in materials and workmanship under normal use for one year after date of shipment. Any part that is determined by the manufacturer to be defective in material or workmanship and returned to the factory, shipping costs prepaid, will be, as the exclusive remedy, repaired or replaced at our option.
