Operation Manual

32
6.CHAPTER
SYSTEM BIOS INFORMATION USING BIOS ACTIVELY
Using BIOS actively
This section explains points on the integrated software of your Interactive Monitor. This BIOS (Basic
Input Output System) software cluster, critical for your device, is stored on a chip on the mainboard. With
this software, your hardware shall be matched with the selected operating system and the system shall
be prepared in coordination. BIOS includes both POST (Power On Self Test) and Aptio Installation
Software sections. POST provides methods for system control during system restart and SCU provides
configuration of your Interactive Monitor.
Using Aptio Installation Software
With the Aptio Installation Software, sub-systems such as system configuration, basic features, startup
configuration and power management may be adjusted. These adjustments are stored in
permanent CMOS memory and is protected even if your system is shut down.
Note: Images given below are for reference purposes only. Different adjustment menus may
be available on the you have as per different versions. Please consider the Bios information
available on your .
Settings
In order to enter Aptio Installation Software, you shall press “DEL” key when you see the Bios logo
while your system is starting up. Usually, Bios logo is displayed for just a few seconds when you turn
on your system. If your Interactive Monitor system is on, turn off your system with the “Restart” option
and press “DEL” key when you see the Bios logo. Aptio Installation Software menü shall be displayed
instantly.