Technical information

Fig. 1 - CE 6.0 installation, supported CPU selection
Board-Support-Package Installation
To install and use ICOP_Vortex86_60CS BSP with CE 6.0, after CE 6.0 is installed (with x86
CPU support), run the ICOP_Vortex86_60CS_BSP.msi from the JumpStart CD. It’s located in
the CD’s BSP folder.
Note: x86 CPU support for CE 6.0 PB is needed in order to use ICOP_Vortex86_60CS BSP
to create OS Design and build CE 6.0 image for eBox-2300.
VS2005 CoreCon Component Installation
Corecon component files for x86 devices are included as part of VS2005 installation and located
in the following default installation folder.
..\Program Files\Common Files\Microsoft Shared\CoreCon\1.0\Target\WCE400\x86\
There are different sets of Corecon component files to support different type of CPU, and located
in the relative folder with name of the CPU.
..\Program Files\Common Files\Microsoft Shared\CoreCon\1.0\Target\WCE400\<CPU>\
CoreCon files can be copied to a CE 6.0 image after the image is built, and use them to establish
link between the CE 6.0 device and VS2005 development station. The need to copy CoreCon
files to a CE 6.0 device every time after reset to establish link with VS2005 development station
is inefficient and waste of precious development time.
A CoreCon catalog component for CE 6.0, in MSI self installable file format, is provided with
the JumpStart kit CD. To install, locate and execute VS2005_CoreCon_x86_WINCE600.msi
on the CD. It’s located in the CD’s CoreCon folder. After installation, The CoreCon component
shows up on CE 6.0 Platform Builder Component catalog as “ConMan_x86 Files Component”.
By including this component as part of an OS Design, CoreCon files will be compiled into the
resulting CE 6.0 image.
eBox-2300 Windows Embedded CE 6.0 JumpStart rev 3.5 Page 8 of 53