Technical information

eBox-2300 JumpStart Kit
eBox-2300 JumpStart kit includes the following
• An eBox-2300 embedded system with 128MB RAM and a 256MB EmbedDisk (IDE
bootable flash storage) & power supply.
The eBox-2300 is pre-configured to boot to DOS and provide various options to load the
Windows CE image. A pre-built Windows Embedded CE 6.0 image is included.
• Windows Embedded CE 6.0 Platform Builder evaluation version CD/DVD
This is a fully functional 180-day evaluation version of Windows Embedded CE 6.0
Platform Builder. A 180-day evaluation version of Visual Studio 2005 Professional is
also included.
• An eBox-2300 Windows Embedded CE 6.0 JumpStart CD
ICOP_Vortex86_60CS Board-Support-Package, SDK and a pre-built Windows
Embedded CE 6.0 image are on this CD along with other resources.
• One RJ-45 Ethernet Crossover cable
With a crossover Ethernet cable and proper static IP address settings, Windows CE
device can be connected directly to the development workstation to create a stand alone
development environment.
• One DB-9 female to DB-9 female null modem serial cable
The null modem serial cable is used to connect between COM1 of the Windows CE
device to an available serial port on the development workstation. Debug messages from
the Windows CE device can be captured by using Hyper Terminal, with serial port
setting setup for 38400 Baud and 8 data bits-No parity-1 stop bit.
eBox-2300 Windows Embedded CE 6.0 JumpStart rev 3.5 Page 3 of 53