User manual

05 ACCESSORIES AND BATTERY
VERTU
5-5
VEHICLE CHARGER
The vehicle charger recharges your Vertu phone battery
quickly and safely from a standard 12 or 24 volt (DC) vehicle
cigarette lighter outlet.
Only use the vehicle charger specifically designed for use
with your Vertu phone.
Never attempt to use a vehicle charger if it has been
damaged.
Only use the vehicle charger in a stationary vehicle.
The time taken to charge your battery depends on its existing
charge. It takes approximately 90 minutes to charge the
battery. You can use your phone normally during the charging
process.
Some cigarette lighter sockets are only powered when the
vehicle ignition is switched on.
The vibrating alert is disabled while the charger is
connected to your Vertu phone.
When the battery is fully charged, the battery charge
indicator stops animating. Disconnect the car charger from
the cigarette lighter outlet before you unplug it from your
phone.
> Attach the charger cable into
the adaptor body.
> Insert the charger connector
into the bottom of your Vertu
phone as shown.
> Connect the charger to the
powered cigarette lighter outlet.
> The green indicator light will
illuminate to show the charger is
connected to the power outlet.
A confirmation message is
displayed if your Vertu phone is
switched on.
DATA CABLE
The data cable, when used in conjunction with a
compatible computer, allows you to use the Vertu Data
Suite software supplied on the CD-ROM to manage your
phone. The data cable also enables you to use your Vertu
phone as a modem to transfer data, or send and receive
faxes. For more information on using your Vertu phone as
a modem contact your service provider.
You will need to install Vertu Data Suite in order to use
your Vertu phone as a modem.
CONNECTING THE DATA CABLE
The headset will not operate if the headset connector
is plugged into the back of the data cable connector.
> Connect the end of the data
cable with the screws
attached to the Serial (COM)
port of your compatible
computer, ensuring it is seated
properly.
> Tighten the screws.
> Ensure your Vertu phone is
switched on.
> Insert the data cable
connector into the bottom of
your Vertu phone as shown
(Your data cable connector
may be slightly different to the
one shown).
If necessary, with the data cable
inserted, you can also connect
the charger to your Vertu phone.
> Plug the charger connector
into the back of the data cable
connector as shown.
Usermanual.book Page 5 Wednesday, January 26, 2005 3:17 PM