User's Manual
Table Of Contents
- contents
- about this manual
- care and maintenance
- welcome
- Hallmarks
- battery information
- safety points
- 01 getting started
- 02 the menus
- 03 the directory
- 04 advanced call functions
- 05 accessories
- 06 security information
- appendix 1 short-cuts
- Safety information
5-5
N
o
.
05 accessories
DATA CABLE
The data cable, when used in conjunction with the
software supplied on the CD-ROM, allows you to back
up and restore phone settings to a personal computer
(PC). You may also use the phone as a modem to gain
access to the internet.
Full instructions are detailed on the CD-ROM.
Installing the cable:
> Connect the end with the
screws attached into the
COM port of your PC
ensuring it is seated
properly.
> Tighten the screws.
> Ensure your phone is
switched on.
> Insert the opposite end
into the connector of
your phone.
> A confirmation message
appears in the display.
> With the data cable
inserted, the charger may
also be connected.
> Plug this into the back of
the data cable connector
as shown.
PEDESTAL
The elegant pedestal serves as a natural resting place to
protect and display your Vertu phone when it is not in
use. It also provides a safe and convenient place to
recharge the phone’s battery and perform data transfer
when connected to a PC.
Install your phone as shown below.
USING THE PEDESTAL
The connector is protected by a dampening platform
which moves out of the way when the phone is inserted
correctly.
Take care that the phone is seated properly before
completing the connection as forcing the connection
when mis-aligned could cause serious damage to the
pedestal, phone, or both.
To remove the phone from the pedestal:
> Grasp the phone and pull slowly upwards with a
smooth vertical motion.
> If a lanyard is attached, gather up the lanyard and
position it so that it travels up the centre of the
back of the phone. Then grasp the phone and pull
slowly upwards with a smooth vertical motion.
>
.
Ensure that the phone
and pedestal are
facing forward (logo to
front).
> Whilst holding the
phone vertically above
the pedestal, slowly
slide it down the guide
channels until it makes
contact with connector
A.
> If the lanyard is attached,
hold the lanyard so that it
travels up the centre of
the back of the phone.
with the link pointing
back and slightly
upwards—out of the path
of the connector.
A