User guide

IP2007 Product Description 1-7
Chapter 1 - Introduction
Xcelerator IP User Guide March 2007
IP Phone Rear & Side Views
The following illustrates the rear and side views of the IP phone. Refer to the callout
numbers, and associated simple description of the part in the following table.
No. Part Name Description of Function
1 LCD screen cover The back of the LCD screen
2 Wall-Mount Hole For mounting the phone on the wall
3 Hinge of Stand A leg is installed here to support the IP phone at different
angles. For wall-mounting, remove the leg.
4 Service door The Service Door is only for engineering use. Inside, there
is a console port. Users should not open this door.
[Note: To use this port, you need a special converter cable
(RJ-45 to DB-9)]
5 Input/Output ports For installation, connect the cables here (refer to the next
figure and associated table for the details).
6 Hinge of Chassis The small frame is fixed here. You do not need to
disassemble this frame for wall-mounting.
7 The back of Cradle This is the back cover of the handset cradle.
8 Product label This shows product production information, including
product model, serial number, and MAC address.
9 Handset cord port RJ-9 jack on the side of IP phone.
10 Handset wire port RJ-9 jack on the side of IP phone.