Specifications

3-10 Trunk Group
Chapter 3 - System Functions
Xcelerator IP Administrator Manual March 2007
Trunk Group
The Trunk Group feature ia used to assign each PSTN Trunk and IP Trunk to a specific
Trunk Group. Each Trunk can be assigned to only one Trunk Group. The Trunk group
assignment is used for Trunk pool access. If setting some PSTN trunks and some IP
trunks into the same Trunk Group, the trunk access sequence will depend on the access
priority. The Xcelerator IP provides up to 4 Trunk Groups. All PSTN Trunks and IP Trunks
are assigned to default Trunk Group 1 and PSTN Trunks have a higher access priority.
Wizard Setup
The Xcelerator IP has a setup Wizard that provides the system administrator with a series
of step-by-step operations. The setup Wizard starts automatically when the Xcelerator IP
is powered up for the first time, or if the system is reset to default configuration via the
reset switch on the Xcelerator IP unit. The following programming/operation areas are
supported through the setup Wizard:
 WAN Setting
 LAN Setting
 Wireless Basic
 Wireless Security
 Internet Time
 Numbering Plan
 IP Trunk
 Call Routing Table
The Xcelerator IP default configuration provides the user with a preset configuration that
will allow the system to come online and operate once analog CO trunks are attached to
the system. The system defaults are contained in the setup Wizard and are displayed in
the user screen examples in the Installation section of this manual.