Owner`s manual

AccessLine Communications

Owners Manual AccessLine 5-4-10

LAN

(back of unit)

Indicates where the Ethernet cable

connects (the other end of the

Ethernet cable connects to the Vertical

Xcelerator Base Unit)

LINE

(back of unit)

Indicates the Telephone Line

Connection port (PSTN), which is not

used.

Registering a Cordless Phone

Each Cordless Phone must be registered with your CORDLESS

TRANSMITTER before it can be used. If the Cordless Phone is

not registered, one of the following messages appears on the

Cordless Phone displays:

Searching for Gateway

Please place Cordless Phone in charger to start auto-registration

with the gateway.

Reset the gateway to enable registration mode.

To register your Cordless Phone do the following.

1. Ensure the base unit is connected to power.

2. Place the Cordless Phone in the charger.

3. If the Cordless Phone does not register automatically, press

and release the RESET button on the rear of the CORDLESS

TRANSMITTER.

Pressing RESET reboots the CORDLESS TRANSMITTER,

following which it remains in registration mode for 5 minutes.

More than one Cordless Phone can be registered in this period.

To start a new 5 minute registration period, press and release the

RESET button again. Successful registration ends with the idle

screen on the Cordless Phone as shown in the section Cordless

Phone Idle Screen on page 62.

Note

If you encounter problems registering your Cordless Phone,

try removing the Cordless Phone from the charger for

approximately 5 seconds, and then replacing it in the charger,

and then resetting the CORDLESS TRANSMITTER once

again.