Owner`s manual

AccessLine Communications
Owners Manual AccessLine 5-4-10
59
called from any phone. This section describes the function of the
lights on the Cordless Transmitter and some of the initial phone
startup screens.
Cordless Transmitter Basics
The Cordless Transmitter plugs into the Vertical Base Unit and
provides wireless connectivity to the Cordless Phones. The Lights
on the front of the Cordless Transmitter indicate the current status.
After the initial installation and activation, the POWER and I-NET
and VOIP lights should remain lit.
The following describes the indicator lights, ports and buttons on the
Cordless Transmitter which, in turn, provides information on the
operating state.
Label Description
POWER
Remains lit when the power is on.
I-NET
Remains lit when the Cordless
Transmitter has an IP address and has
been connected to the Vertical
Xcelerator Base Unit. Flashes during
boot.
VOIP
Remains lit when the Cordless
Transmitter is connected to the
Vertical Base Unit and the Vertical
Base Unit is communicating with the
AccessLine Network
CALL
Remains lit when a call is in progress
RESET
(back of unit)
Press momentarily to reboot the unit,
activate configuration changes, and
enable Cordless Phone registration
mode.
Press and hold 15 seconds to reboot
with factory default settings. All front
panel lights come on when a factory
restart is initiated.
NOTE: Any custom configuration
settings are lost during a factory
default.
DC 9-20V
(back of unit)
Indicates where the power plug
connects