Owner`s manual

AccessLine Communications

Owners Manual AccessLine 5-4-10

“Registering to Gateway”. This will also begin to charge the

battery. It is recommended that you charge the battery fully

before first use. This takes approximately 10 hours.

Note

You may see the message “Please place handset in charger

to start auto registration with the gateway. Restart the

gateway to enable the registration mode”. If so, you will need

to remove the handset from its cradle for a few seconds and

then return it to its cradle. The display will then flash the

message “Registering to Gateway”.

Registering Cordless Phones:

9. Momentarily depress the reset button on the rear of the

Cordless Transmitter. This will place the transmitter into

“handset registration mode”, allowing it to automatically register

with the new Cordless Handsets for a period of 5 minutes.

Within a few minutes the Cordless Phone should complete their

registration with the Cordless Transmitter and the display will

show “Ext 117”, “Ext 118”, or “Ext 119”, depending on how many

handsets you have purchased.

Activating the Service

You have installed your phone system and now it is time to activate

your phone lines. Go to www.accessline.com/activate

1. Enter the MAC address found on the back of the Vertical

Xcelerator base unit