Owner`s manual

AccessLine Communications
Owners Manual AccessLine 5-4-10
26
Connecting your Existing Phone Line(s)
Skip this section if you do not intend to use existing phone lines
You may connect up to 3 existing phone lines (called CO lines) into
the Xcelerator phone system. This is generally done when you first
receive the system and are in the process of porting the phone
number on that line to AccessLine. This way, you can continue to
use that phone number and phone line with the Xcelerator phone
system until the number has been ported. To do so, plug the
existing phone line (s) into the orange line socket(s) labeled CO
Line 1, CO Line 2 or CO Line 3 on the back of the base unit.
Note
Any call coming in on any CO line will always ring at extension
100
Setting up the Stand
Setting Up the Stand
Refer to the following steps and the associated illustration to setup
the stand of the Desk phone.
Step A Move the big U-type frame (4) downward.
Step B Move the big U-type frame (4) downward to the flat level.
The small U-type frame (5) will get flat concurrently.
Step C Move the U-type leg (3) upward.
Step D Seat the U-type leg (3) onto the big U-type frame (4) at
about a 30º-angle position.
-Or-
Step E Pull-in the U-type leg (3) and seat it at about a 45º-angle
position in the big U-type frame (4).
-Or-