User guide

Wave Phone User Guide July 2007 - Issue 1.0 3-39
Chapter 3 - Using Wave Phone Features Mute
MUTE
This feature allows you to prevent the caller at the distant end to hear anything
through your microphone or handset during a call.
Note: If the Mute is enabled (on)via the speaker, it will be disabled (off) if you
lift the handset
Muting a Call [S] / [D]
For SIP & DIGITAL Phones
To mute a call:
While on a call, press MUTE () to mute the microphone or handset.
The MUTE LED is solid red. You can hear the other party, but the other
party cannot hear you.
If you are on a hands-free call, the SPEAKER LED is solid red.
To speak to your caller:
Press MUTE () again.
The MUTE LED will be cleared.
NIGHT ANSWER
By using the Night Answer feature, you can manually place an Vertical Wave
system into a mode where all inbound calls to the Vertical Wave system are
redirected to a predetermined destination. Your system administrator can
configure any on- or off-premise phone number as the destination.
Setting Night Answer [ALL]
For SIP & ANALOG Phones
To turn on the Night Answer Service:
Press *85.
To turn off the Night Answer Service:
Press *86.