User guide

Wave Phone User Guide July 2007 - Issue 1.0 3-35
Chapter 3 - Using Wave Phone Features Hold
For Digital Phones
To place a call on hold
Press HOLD.
When a call is on hold, the red LED flashes next to the corresponding
line or call appearance key.
You can hang up the handset or use other phone features.
If you leave the call on hold for longer than the system hold time (three
minutes is the default), your phone rings back and
HELD is displayed.
Note: The FLASH key can be used to place calls on temporary hold.
However, you cannot hang up the handset or you will be reconnected to
the call on hold.
To reconnect to a call on hold
Press the line or call appearance key that corresponds to the call that was
placed on hold, or press the TAP key to retrieve the most recently held
call.
Hint: If more than one call has been placed on hold, press TAP, then the
HOLD key while not connected to a call will scroll through all calls on hold.
When the desired call is shown on the display, press TAP to retrieve that
one.
For ANALOG Phones
Place the current call on hold while you use other phone features.
To place a call on hold:
1. With a party on the line, press FLASH, then #, then *64.
2. Listen for two beeps.
3. Hang up.
Reconnect to a call on hold:
1. Listen for dial tone.
2. Press *65, then #.